Troubleshooting MaCave
29
The light does not work. Appliance is not connected to a
power supply
Connect the appliance
Circuit breaker or fuse has blown Switch on circuit breaker or
replace fuse
The light was switched off on the
control panel.
Switch on the light
The appliance vibrates The appliance is not properly
level
Level the appliance with the
adjustable feet
The appliance seems to
make a lot of noise
The noise is probably caused by the refrigerant, which is normal.
At the end of each cycle, you will hear noises made by the flow of
refrigerant.
If temperature fluctuations occur, the contraction and expansion
of the inner walls may cause popping and cracking noises.
The appliance is not properly
level
Level the appliance with the
adjustable feet
The door does not close
properly
The appliance is not properly
level
Level the appliance with the
adjustable feet
The door hinge was changed
incorrectly
Check the door hinge and
reassemble correctly
The door seal is dirty Clean the door seal
The shelves are not fitted cor-
rectly
Check the shelves and refit
correctly
LED indicates E1, E2 or E7. The temperature sensor for the
fan inside the appliance shows
an error
This can only be repaired by
an authorised repair centre.
Problem Possible cause Remedy
To Next Page
Loading...
Need help?
General
