MC052, MC054 Operating the coffee maker
11
A
Setting up the coffee maker
Install the coffee maker on a wall (fig. 3, page 4) or a work surface (fig. 4, page 4).
1. Install the mounting bracket using the four screws supplied
– to a suitable wall or
– to a work surface.
2. Push the coffee maker onto the mounting bracket.
The coffee maker must lock into place on the mounting bracket.
Connecting the coffee maker
➤ Connect the DC plug to a DC socket.
I
8 Operating the coffee maker
A
Before first use
1. Allow one to two pots of clear, cold water to boil and flow through without the
filter or coffee.
NOTICE! Damage hazard
• Only install the appliance on surfaces which are heat-resistant and
damp-proof.
• Make sure there is sufficient space for the drill head to emerge when
drilling.
NOTE
You can also connect the coffee maker directly to the battery.
Observe the following in the process:
• The connection must be fitted with a fuse of its own of at least 20 A.
• The connection cable may not exceed a length of 5 m for the
MC052 (12 V) or 11 m for the MC054 (24 V).
• The cross section must be at least 4 mm².
NOTICE! Damage hazard
• Secure the coffee pot with the clip when using it to ensure that the
pot cannot tip over.
• Observe the charge level of the battery when operating the appli-
ance in vehicles with the engine turned off.
• Wipe up any spilt liquid. Damage to the electronics may be caused
by moisture entering the appliance.
DometicMC052-MC054_IOM_4445101699_EMEA17_20xx-xx-xx.book Page 11 Tuesday, August 3, 2021 12:04 PM
To Next Page
Loading...
Need help?
General
