Operating the awning PW1000, PW1500, PW1750
20
➤ Press the button of the switch or the remote control until the awning is
extended to the required position. Position the struts vertically and back under
the lead rail every 30 cm so that the awning stays secured at all times.
➤ Press the switch of the switch or the remote control until the awning has
retracted far enough to tauten the fabric.
A
Positioning the struts on the ground
!
➤ Position the struts vertically underneath the lead rail.
➤ Secure the struts with pegs (fig. 9, page 6).
➤ Position one of the struts slightly lower so that the lead rail hangs at an angle. This
allows rain to run off more easily (fig. 0, page 6).
Securing the struts on the vehicle
You can secure the awning on your vehicle directly if you have already mounted the
latches for the struts.
➤ Slide the cover of the latch up (fig. a, page 7).
➤ Fit the struts into the latch (fig. a, page 7).
➤ Slide the cover of the latch down (fig. a, page 7).
➤ Position one of the struts slightly lower so that the lead rail hangs at an angle. This
allows rain to run off more easily (fig. b, page 7).
NOTICE! Beware of damage.
The fabric of the awning should not hang down at the edges, and must
remain taut at all times. If the fabric hangs down, it could rub against the
arms and become damaged.
The fabric used for long awnings should not sag in the middle.
WARNING! Beware of injury
• Only position the struts on solid ground.
• Secure the struts from slipping.
PW1000-PW1500-PW1750-O-16S.book Seite 20 Donnerstag, 5. Oktober 2017 11:05 11
More information https://www.caravansplus.com.au
To Next Page
Loading...
