Dometic RF60 - Using the Device in Gas Mode

EN
RF60, RF62 Operation
25
It takes about 1 h until the interior becomes noticeable cool. After approx. 5 h
you can set the thermostat to a lower temperature.
➤ To increase the cooling level, turn the thermostat (3) clockwise.
➤ To decrease the cooling level, turn the thermostat (3) anticlockwise.
Turning off the device (fig. 2, page 3)
1. Turn the energy selector switch (1) to the  position.
2. Turn the thermostat (3) to the  position.
✔ The device is switched off.
7.4 Using the device in gas mode
Turning on the device (fig. 2, page 3)
1. Turn the energy selector switch (1) to the position.
2. Open the gas supply at the gas cylinder.
3. Turn the thermostat (3) to the MAX position.
4. Press down the thermostat (3) and keep it pressed.
5. After 10 s press the ignition button (4) several times, until the flame is lit.
6. For devices with electronic ignition the ignition button (4) has to be kept down
for some seconds. Due to air in the pipes, this may take more than 10 s when the
device was out of operation for a longer time or when the gas cylinder was
replaced.
7. After ignition keep the thermostat (3) pressed for another 30 s.
8. Release the thermostat (3).
✔ The flame can be controlled by the flame indicator (2).
✔ The device starts cooling the interior.
It takes about 1 h until the interior becomes noticeable cool. After approx. 5 h
you can set the thermostat to a lower temperature.
I
➤ To increase the cooling level, turn the thermostat (3) clockwise.
➤ To decrease the cooling level, turn the thermostat (3) anticlockwise.
NOTE
If the flame does not light up, repeat the ignition procedure after 1 min.