8
Gas operation
1. Open the valve of the gas cylinder
2. Open the shut-off valve to the gas supply.
The ignition process is activated automatically, accompanied by a ticking sound
approx. 30 sec. Upon successful ignition, the display LED (C) “Gas” lights yellow.
The refrigerator is in function. Use rotary switch (B) to regulate the temperature in the
main refrigerator compartment.
Gas faults
Remedies:
Set the energy selector switch (A) to position “OFF”.
1. Is there any gas in the gas bottle?
2. Is the gas bottle valve open?
3. Is the on-board shut-off valve open?
4. Set the main switch (A) to “on”
The reignition starts again.
If after about 30 seconds the operating display (C) starts flashing
again, the gas fault has not been cleared (e.g. air in the gas pipe).
5. Briefly switch the refrigerator off and then on again using main switch (A).
To remove air from the gas pipes, repeat this procedure 3-4 times.
If these actions do not help, please call the Dometic Service Centre.
5.2.3
5.2.4
The refrigerator should only be operated using liquid gas
(Propane, Butane). Do not use Autogas, town gas or natural gas.
If the refrigerator is operated during travel using gas, the precautions
stipulated by the legislation in the respective country must be taken (in
conformity with the European standard EN 732).
Due to physical reasons, ignition faults could occur starting from an
altitude above sea level of approx. 1000 m /3280 ft. (No malfunction!)
As a basic rule, operation using gas is prohibited in petrol stations.
1. Set energy selector switch (A) to gas
2. Set rotary switch (B) to “MAX” postion.
A
C
C
A
In the event of a gas fault (e.g. gas cylinder empty),
the operating display (C) flashes yellow.
WARNING
To Next Page
Loading...
Need help?
General
