Dometic RM2310 - Door Adjustments and Panel Mounting

12. Changing door hinges from one side to the other
(Refer to Figure 11)
A.
B.
C.
D.
E.
F.
G.
Remove the top hinge pin and lift out the door.
Remove lower hinge pin (including washers)and
relocate them to the hole on the opposite side
hinge.
Unscrew the travel latch and relocate it on the
opposite side.
The bushing and the latch retainer on the top of
the door should be reversed.
Replace the door back on the refrigerator and
install the top hinge pin.
Remove the door handle and refasten it on the
opposite side. Insert the plastic caps (found in the
miscellaneous parts bag) into the screw holes left
open on the door.
Check the door to determine if it opens and closes
easily and the gaskets seal on all sides; also make
sure the travel catch operates properly. If
adjustments are required, remove the plastic
cover snapped over the top hinge, loosen the two
screws and reposition the door. Tighten the
screws and replace the plastic cover.
e
Relocatkavel
latch to opposite side p
I
\
0
Replace door and
install top hinge pin
i
13. Instructions for mounting the door panel
The refrigerator is normally delivered without door
panels(s). Before starting the mounting work, check the
panel dimensions for compliance with those given in the
Table below, and read the instructions thoroughly. (See
Fig. 12). When mounting the panel, proceed as follows:
A.
B.
C.
D.
E.
F.
The decoration strip(s) are taped inside the door.
If installed on thedoor, removethedoordecoration
strip (2) by removing its two screws (1).
Insert one of the vertical edges of the panel into the
groove of the door frame (3).
Bend the panel gently so that the free side of the
panel can be slipped into the corresponding
groove of the door frame (4).
Slide the panel down into the groove of the bottom
frame (5).
Between the upper edge of the panel and the door
frame there is a gap which should be covered by
the decoration strip.
Put the decoration strip across the door so that the
gap is covered and push upward (6). The tabs on
the inside of the strip should fit in behind the flange
of the door frame. Secure the decoration strip with
the two screws removed in Step A(1).
PANEL DIMENSIONS
MAX. THICKNESS 5/32” (4mm)
Relocate
$4
hinge pin
washer
lower
and
Move door
handle to
opposite
side
0
, Reverse bushing
and latch retainer
-7-