Troubleshooting RMD10.5(X)(T)(S)
34
RMD10.5T,
RMD10.5XT
RMD10.5,
RMD10.5X,
RMD10.5S,
RMD10.5XS
Fault Solution
E03 No connection between
power module and display
Contact an authorized customer
service.
E07 No cooling capacity in gas
mode
Check if the device is at an angle
and adjust it if necessary.
Reset the error.
Contact customer service if this
error occurs again.
E08 No cooling power in AC
mode
Check if the device is at an angle
and adjust it if necessary.
Reset the error.
Contact customer service if this
error occurs again.
E09 No cooling power in DC
mode
Check if the device is at an angle
and adjust it if necessary.
Reset the error.
Contact customer service if this
error occurs again.
E12 Gas valve check error Gas operation is not possible.
Reset the error.
Contact customer service if this
error occurs again.
E13 Internal communication error Gas operation not possible.
Reset the error.
Contact customer service if this
error occurs again.
E14 In stand-alone gas mode:
The battery charge of the
battery packs is too low
Insert new batteries and then reset
the error.
E50 Gas lock after 3 ignition
attempts
Ignition not possible.
The gas cylinder is empty. Replace
the gas cylinder.
Reset the error.
DometicRMD10_OPM_4445103406_EMEA(18)_20xx-xx-xx.book Seite 34 Freitag, 4. Juni 2021 7:14 07
To Next Page
Loading...
Need help?
General
