6
Check the outboard engine manufacturer’s instructions carefully
for specifications regarding connection hardware. Ensure the
outboard engine manufacturer’s requirements are followed.
WARNING
The use of a transom stiffener for the top bolts on the transom side
of the jackplate-to-transom connection is recommended.
NOTICE
[
1
] Jackplate
[
3]
Rocker Switch
[
2
] Relay Wiring Harness
[
4]
Spade Terminals (Female)
Figure 4. Included parts.
The following parts are included with your SeaStar Jackplate
product. If any of these components are missing, contact your
dealer or Dometic.
To Next Page
Loading...