SMP301 Safety instructions
11
2.2 Safety when installing the product
!
WARNING!
• The electrical installation may only be connected by qualified person-
nel and only in accordance with the national regulations. Incorrect
connection may cause severe hazards.
• Take the precautions necessary to ensure that children cannot inter-
fere with the product.
Dangerous situations may occur which cannot be recognized by chil-
dren!
A
NOTICE!
• Do not expose the product to any heat source (such as direct sunlight
or heating). Avoid additional heating of the device in this way.
Electrical cables
!
CAUTION!
• Lay the cables so that they cannot be tripped over or damaged.
• Have damaged power cables replaced by a specialist in accordance
with national regulations.
A
NOTICE!
• If cables have to be fed through metal walls or other walls with sharp
edges, use ducts or bushings to prevent damage.
• Do not lay cables that are loose or sharply bent next to electrically con-
ductive material (metal).
• Do not pull on the cables.
• Do not lay the AC cable and the DC cable in the same duct.
• Firmly secure the cables.
2.3 Operating the product safely
!
WARNING!
• Operate the product only if you are certain that the casing and the
cables are undamaged.
• Always disconnect the power supply when working on the product.
SMP301-01-02-03-04-05-10--IO-7s.book Seite 11 Mittwoch, 23. Oktober 2019 11:56 11
To Next Page
Loading...
