Domnick Hunter Maxigas 120

Questions and Answers

A
amanda72Aug 7, 2025
What to do if my Domnick Hunter Maxigas 120 has no or low gas outlet pressure?
- T
  Theresa JohnsonAug 7, 2025
  If your Domnick Hunter Portable Generator has no or low gas outlet pressure, it could be due to several reasons. The generator might be overdue for service, in which case you should service it. There could also be an internal or external gas leak, which requires checking and rectification. Finally, the inlet pressure may be too low; ensure it meets the required specification.
L
leblanclynnAug 12, 2025
How to fix excessive noise or vibration in my Domnick Hunter Maxigas 120 Portable Generator?
- L
  Luis WoodsAug 12, 2025
  Excessive noise or vibration in your Domnick Hunter Portable Generator can stem from a few sources. First, check if the silencer is loose or defective and rectify as needed. Second, inspect the solenoid valve for wear or a loose coil; check and replace if required.
T
Tracy SmithAug 17, 2025
What to do if my Domnick Hunter Portable Generator shows power connected but LCD and status indicators are not illuminated?
- A
  Anthony EscobarAug 17, 2025
  If your Domnick Hunter Portable Generator is connected to power but the LCD and status indicators are not illuminated, it could be due to a blown fuse (replace the fuse), a disconnected ribbon cable (reconnect the ribbon cable), or the power may not be properly connected (reconnect the power).
N
Nicholas LeblancAug 22, 2025
Why is there a high oxygen concentration in my Domnick Hunter Portable Generator?
- C
  christian82Aug 22, 2025
  A high oxygen concentration in your Domnick Hunter Portable Generator may be caused by a defective oxygen cell, which you should replace. Another possible cause is a leak in the system piping, which requires checking and rectification.
B
Brenda StewartAug 27, 2025
What causes low inlet pressure in a Domnick Hunter Maxigas 120 Portable Generator?
- G
  George EllisAug 28, 2025
  Low inlet pressure in your Domnick Hunter Portable Generator can be attributed to a few reasons: the compressor or ring main pressure might be low, requiring a check and rectification. Alternatively, the inlet valve may not be open, which also requires checking and rectification. Finally, there might be a defect on the pre-treatment package; refer to the pre-treatment manual.
P
Patrick HayesSep 1, 2025
What causes high outlet pressure in my Domnick Hunter Maxigas 120?
- N
  Nathan BrooksSep 1, 2025
  High outlet pressure in your Domnick Hunter Portable Generator is caused by a defective outlet regulator. Reset or replace it.