To activate sleep settings, press on sleep function button making sure appliance
is already set to the Cooling (down) Mode.
The top ventilator will switch automatically to low speed. After one hour the selected
temperature will increase by 1°C, and by 2°C after two hours. After six hours the
appliance will automatically switch off.
The control panel has a memory function that stores the mode last used. This memory
function remains active for as long as the appliance remains on standby (with the
exception of mode).
REMOTE CONTROL
button. For switching the appliance on and off.
button. Use this to select the desired function.
button. Select the desired ventilation speed
▲ button. For increasing the temperature or adjusting
timer.
▼ button. For decreasing the temperature or adjusting
timer.
button. Activate of deactivate the sleep setting.
button. Activate or deactivate the automatic timer
function.
Placing Battery in the Remote Control
Slide the cover to open at back. Place a battery in the correct position in the remote
control. Slide the cover back into place. Make sure
the positive and negative markers correspond with the
markings on the remote control.
If you are not going to use the remote control for an
extended period remove the batterie.Always dispose of
used batteries in a responsible manner, give them to a
processing rm or waste processing company. Point the
remote control towards the infrared receptor in your appliance. The remote control has
a maximum range of 7 metres.
INSTALLING THE AIR OUTLET PIPE
1. Air pipe
2. Appliance connection adaptor
3. Wall tting for outlet pipe
4. Remote control
30
To Next Page
Loading...
Need help?
General
