Domo DO417KT - Power Cord; Instructions for Use

DO417KT
en than rell.
Never place the carafe on a hot surface or in a hot oven.
Don’t touch the cord or the hot surface of the appliance when it is working.
Don’t use any abrasive cleaners or rough spounge for cleaning he appliance.
POWER CORD
The appliance has a short power cord to prevent tripping or entaglement.
Be very carefull when using an extention cord.
When using an extention cord, think of the following :
- The indicated power of the extenion cord needs to be at least the same as the
appliance
- Make sure the extention cord is not draped over the table or counter top, children
could pull it or you could trip over it.
INSTRUCTIONS FOR USE
First use :
Let clean water run through the coffee maker twice.
Take the carafe.
Open the lid of the water tank.
Fill the carafe with the necessary amount of water en pour it into the water tank. Never
use warm water.
Place a paper lter in the lter holder.
Fill the paper lter with the desired amount of coffee.
Place the carafe with the lid on the plate of the appliance.
Turn on the coffee maker by pressing the “on/off” button. The indication light will
light up.
When the coffee is nished, you can take off the carafe. If you want to take coffee
when the water is still running, the drip stop will prevent coffee dripping on the hot
plate.
ATTENTION : the drip stop only functions when the lid is on the carafe.
When the coffee is nished, you can take the carafe of the hot plate.
Afterwards place the carafe back on the hot plate.
As long as your coffee maker is on the coffee will be kept warm.
When no longer necessary, turn off the coffee maker.
After 2 hours the coffee maker will switch off automatically.
ATTENTION : let the appliance cool down for 5 min. between every time you make
coffee.
PROGRAMMING YOUR APPLIANCE
The timer makes it possible to program your coffee maker, so it will automatically
switch on at the desired hour.