Domo DO936DVK - Before the First Use

35
DO936DVK
www.domo-elektro.be
EN
PARTS
1. Handle
2. Drainage opening
3. Storage basket
4. Temperature control knob
BEFORE THE FIRST USE
INSTALLATION
· Remove the exterior and interior packing, wipe the outside thoroughly with a soft dry cloth
and the inside with a wet, lukewarm cloth. Avoid placing the cabinet in a narrow recess
or near any leave source, direct sunlight, or moisture. Let air circulate freely around the
cabinet.
· Select a place with a strong, level oor.
· Avoid direct sunlight and heat. Direct sunlight may aect the acrylic coating. Heat sources
nearby will cause higher electricity consumption.
· Avoid very moist places. Too much moisture in the air will cause frost to from very quickly
on the evaporator, and your freezer.
· Before connecting your freezer to the power supply, check that the voltage stated on the
rating label of your appliance corresponds to the voltage in your home. A dierent voltage
could damage the appliance.
· The appliance must be grounded. The manufacturer is not responsible for damages that
may occur as a result of usage without grounding.
· For uneven surfaces, front feet can be aligned.
· After installation, leave the freezer for 8 hours before turning it on. This way the refrigerant
can settle.
· Allow the appliance to run empty for 24 hours so the compartment can cool to the
appropriate temperature.
· The appliance may only be used indoors.
1
2
3
4