Donggu DG-808F5M - How to supply water; How to supply water (INSIDE WATER TANK USING ONLY); How to cup test; Put into cup barrel;Cup test

Disassemble the material
barrels at first
● Lift the funnel and takeout.
● Take out the barrel by lifting the front side
of it slightly
•Disassemble in the following from left(Tea1) to
right(Tea2)
● The maximum volume of the material containers is
4,400g(10.05lbs)for Tea 1 , 2,800g(6.44lbs) for Tea 2,
1,600g(3.61lbs)
5
How to supply water
How to supply materials
How to supply water
(INSIDE WATER TANK USING ONLY)
1
Open the lid of the
water tank by twisting
the arrow direction as
indicated.
2
Put the water in to the
tank using a big kettle
● Supply the water to reach 3cm
distance from the top of the
water tank.
● If the water overflows or gets
into the assembly, it may cause
the defect of the machine.
Tea 1
Tea 2
Coffee
Available
Unavailable
Mixer coffee(Cafe Latte,
Cappuccino, CafeMoca,etc)
Material
TeaMat
erial
Freshbrew coffee(Linger)
Citron/Tea
Cocoa, Powder Milk
Ginseng tea, Choco
Liquid typecream
Containedgrain tea
soup, stew
(stickymaterial)
6
How to cup test
Put into cup barrel/Cup test
1
Put the paper cups
into cup bucket.
• Put 5~10 cups each time into
the barrel for cup sensor to
operate moderately
2
Press the cup test
button.
• You can see the paper cup
comes out through the outlet
with beep sound
● Do not use substandard ,distorted, deformed or wet cups.
● Do not press the cups to put more cups into the barrel.
● May cause the cup sensor be out of order.
● Use the only 6.5ounce cups,(195ml
standard type)
How to assemble barrels, and supply materials
1
Close the lid after putting the raw materials into the container
• When putting raw materials, incline the barrel slightly backward for the materials not to get
out of the front hole of the barrel.
2
Fix the fixing hole of barrel into the rotating shaft correctly.
• Before assembling containers, make sure that the names of the material shown in a plate
adhered to barrel with those of indicating panel.
Assemble barrels in order
•Tea2 barrel Tea1 barrel(From the left to the right)
3
Put the projecting part located in the lower part of barrel into panel
groove correctly.
Put the raw material funnel into the panel hole correctly.
● Put the raw material into the barrel after removing any moisture from the barrel for the
material not to be hardened due to any moisture.
<DG-707FM> <DG-808F3M>