6 7
Add ice to fill line inside the device.
Add cold water to fill line.
a. CLEAR
Lid – Place lid on the device
making sure the lip inserts into the groove.
Then press the lid down to close and secure.
b. CLASSIC and CLASSIC
Lid – With the
handle down, place lid on device making sure
the label is facing up. Secure the lid by raising
the handle, which will enage the lid locking
mechanism.
Connect the IceMan® hose to the cold pad
hose. To ensure a reliable connection, “snap”
or “click” hoses together into place so that
the fit is tight and snug.
To turn the device on, insert cord into con-
nection on the back of the device and plug
power supply into the wall outlet. (To turn
o the device unplug it.) WARNING! When
applying the cold pad, DO NOT let any part
of the cold pad touch your skin. Always use
with a barrier between your skin and the cold
pad. Apply cold pad to patient. Refer to ap-
plication instructions provided with cold pad.
Check for moisture on the barrier between
the patient’s skin and cold pad. If moisture is
present on the barrier, immediately discon-
tinue use of this device.
For IceMan® CLASSIC
Set temperature control on the hand console
starting at the white dot. Allow minutes
after the cold pad is placed on the patient for
the temperature to stabilize. Then adjust the
temperature to the range prescribed by the
physician.
DO NOT use if you do not have a prescription.
1
2
3
4
5
OPERATING INSTRUCTIONS
6
10
minimum cold
maximum cold
a b
To Next Page
Loading...