Doogee S88 - T MECHANICAL STRENGTH TESTS; T.1 General requirements

- Page 35 of 60 -
Report No. STS200421001001E
IEC/EN 62368-1
Clause Requirement + Test Result - Remark Verdict
Shenzhen NTEK Testing Technology Co., Ltd
Wall thickness (mm) ............................................ :

Conditioning (test condition), (C) ....................... :

Test flame according to IEC 60695-11-20 with
conditions as set out
N/A
After every test specimen was not consumed
completely
N/A
After fifth flame application, flame extinguished
within 1 min
N/A
T MECHANICAL STRENGTH TESTS P
T.1 General requirements P
T.2 Steady force test, 10 N ...................................... : P
T.3 Steady force test, 30 N ...................................... : N/A
T.4 Steady force test, 100 N .................................... : (See appended table T.4) P
T.5 Steady force test, 250 N .................................... : N/A
T.6 Enclosure impact test N/A
Fall test N/A
Swing test N/A
T.7 Drop test ............................................................. : (See appended table T.7) P
T.8 Stress relief test .................................................. : (See appended table T.8) P
T.9 Impact Test (glass) Surface area not exceeding 0.1m
2
N/A
T.9.1 General requirements N/A
T.9.2 Impact test and compliance N/A
Impact energy (J) ................................................... :

Height (m) .............................................................. :

T.10 Glass fragmentation test ....................................... : N/A
T.11 Test for telescoping or rod antennas N/A
Torque value (Nm) .............................................. :

U MECHANICAL STRENGTH OF CATHODE RAY TUBES (CRT) AND PROTECTION
AGAINST THE EFECTS OF IMPLOSION
N/A
U.1 General requirements N/A
U.2 Compliance and test method for non-intrinsically
protected CRTs
N/A
U.3 Protective Screen ................................................... : N/A