Doogee S88Pro - Protective Conductor Requirements

- Page 13 of 60 -
Report No. STS200421001001E
IEC/EN 62368-1
Clause Requirement + Test Result - Remark Verdict
Shenzhen NTEK Testing Technology Co., Ltd
5.5.5 Relays N/A
5.5.6 Resistors N/A
5.5.7 SPD’s N/A
5.5.7.1 Use of an SPD connected to reliable earthing N/A
5.5.7.2 Use of an SPD between mains and protective
earth
N/A
5.5.8 Insulation between the mains and external circuit
consisting of a coaxial cable .............................. :
N/A
5.6 Protective conductor N/A
5.6.2 Requirement for protective conductors N/A
5.6.2.1 General requirements N/A
5.6.2.2 Colour of insulation N/A
5.6.3 Requirement for protective earthing conductors N/A
Protective earthing conductor size (mm
2
) ............ :

5.6.4 Requirement for protective bonding conductors N/A
5.6.4.1 Protective bonding conductors N/A
Protective bonding conductor size (mm
2
). ............ :

5.6.4.2 Protective current rating (A) ............................... :

5.6.4.3 Current limiting and overcurrent protective
devices
N/A
5.6.5 Terminals for protective conductors N/A
5.6.5.1 Requirement N/A
Conductor size (mm
2
), nominal thread diameter
(mm). ................................................................... :
N/A
5.6.5.2 Corrosion N/A
5.6.6 Resistance of the protective system N/A
5.6.6.1 Requirements N/A
5.6.6.2
Test Method Resistance ()................................ :
N/A
5.6.7 Reliable earthing N/A
5.7 Prospective touch voltage, touch current and protective conductor current N/A
5.7.2 Measuring devices and networks N/A
5.7.2.1 Measurement of touch current ............................ : N/A
5.7.2.2 Measurement of prospective touch voltage N/A
5.7.3 Equipment set-up, supply connections and earth
connections
N/A