Doogee S88Pro - Components and Circuits; Protection Devices (Cut-offs, Links)

- Page 24 of 60 -
Report No. STS200421001001E
IEC/EN 62368-1
Clause Requirement + Test Result - Remark Verdict
Shenzhen NTEK Testing Technology Co., Ltd
e) Audio equipment terminals classified as ES3
and other equipment with terminals marked in
accordance F.3.6.1
N/A
f) Protective earthing employed as safeguard N/A
g) Protective earthing conductor current exceeding
ES2 limits
N/A
h) Symbols used on equipment P
i) Permanently connected equipment not provided
with all-pole mains switch
N/A
j) Replaceable components or modules providing
safeguard function
N/A
F.5 Instructional safeguards P
Where “instructional safeguard” is referenced in
the test report it specifies the required elements,
location of marking and/or instruction
P
G COMPONENTS P
G.1 Switches
N/A
G.1.1 General requirements N/A
G.1.2 Ratings, endurance, spacing, maximum load N/A
G.2 Relays
N/A
G.2.1 General requirements N/A
G.2.2 Overload test N/A
G.2.3 Relay controlling connectors supply power N/A
G.2.4 Mains relay, modified as stated in G.2 N/A
G.3 Protection Devices
N/A
G.3.1 Thermal cut-offs No thermal cut-off used. N/A
G.3.1.1a)
&b)
Thermal cut-outs separately approved according
to IEC 60730 with conditions indicated in a) & b)
N/A
G.3.1.1c) Thermal cut-outs tested as part of the equipment
as indicated in c)
N/A
G.3.1.2 Thermal cut-off connections maintained and
secure
N/A
G.3.2 Thermal links N/A
G.3.2.1a) Thermal links separately tested with IEC 60691 No thermal link used. N/A
G.3.2.1b) Thermal links tested as part of the equipment N/A
Aging hours (H) .................................................. :

Single Fault Condition ........................................ :
