Doogee S88Pro - Tests for Resistance to Heat and Fire; Flammability Tests for Fire Enclosures

- Page 34 of 60 -
Report No. STS200421001001E
IEC/EN 62368-1
Clause Requirement + Test Result - Remark Verdict
Shenzhen NTEK Testing Technology Co., Ltd
R LIMITED SHORT CIRCUIT TEST N/A
R.1 General requirements N/A
R.2 Determination of the overcurrent protective
device and circuit
N/A
R.3 Test method Supply voltage (V) and short-circuit
current (A)). ...................................................... :
N/A
S TESTS FOR RESISTANCE TO HEAT AND FIRE N/A
S.1 Flammability test for fire enclosures and fire
barrier materials of equipment where the steady
state power does not exceed 4 000 W
N/A
Samples, material ............................................... :

Wall thickness (mm) ............................................ :

Conditioning (C) ................................................. :

Test flame according to IEC 60695-11-5 with
conditions as set out
N/A
- Material not consumed completely N/A
- Material extinguishes within 30s N/A
- No burning of layer or wrapping tissue N/A
S.2 Flammability test for fire enclosure and fire barrier
integrity
N/A
Samples, material ............................................... :

Wall thickness (mm) ............................................ :

Conditioning (C) ................................................. :

Test flame according to IEC 60695-11-5 with
conditions as set out
N/A
Test specimen does not show any additional hole N/A
S.3 Flammability test for the bottom of a fire
enclosure
N/A
Samples, material ............................................... :

Wall thickness (mm) ............................................ :

Cheesecloth did not ignite N/A
S.4 Flammability classification of materials N/A
S.5 Flammability test for fire enclosures and fire
barrier materials of equipment where the steady
state power does not exceed 4 000 W
N/A
Samples, material ............................................... :
