Fault phenomenon: Turn on the ignition lock, turn the accelerator handlebar, but the motor does not rotate.
Fault reasons and solutions:
① The battery voltage is too low, the controller is under voltage protection: To charge the battery;
② Return of accelerator cable box is not well done: Check whether the accelerator cable is out of the accelerator cable box, need to
install properly
③ Accelerator cable box is damaged: replace the accelerator cable box;
④ Brake switch is not turn off: Check whether the return of brake handle is normal or brake power-off switch is defect, the brake light
does not lighted when you should not pull the brake handle or lift up the stander, you need to repair or replace the brake switch;
⑤ power-off switch of stander did not disconnect: lift up the stander, brake lights are bright, it need to be maintenance or replacement
of stander power-off switch;
⑥ Bad connection between Motor Hall connector and controller: unplug the connector of motor Hall and well re-plug.
⑦ Motor Hall Burnout: Repair motor Hall or replace motor
⑧ Controller burnout: repair or replace the controller
Fault phenomenon: Range is short after the battery is fully charged.
Fault reasons and solutions:
① battery burn-in: replace or repair the battery;
② Lower tire pressure: Need to tire inflation (with standard pressure value)
③ brake disc is attrition by disc brake :disc brake maintenance;
④ Charger fault, the battery can not be fully charged: replace or repair the charger.
One of the phase line of motor is
disconnected.
① Check whether it is well connected for the phase
line of motor and controller.
② if the controller is burnout, replace a new one
The controller is braking state
① Check whether return of brake handle is normal
and brake switch is burnout, replace if necessary.
② Check whether return of switch of side stander is
normal and side stander power-off switch is burnout,
replace if necessary.
Self-inspection error
protection
Abnormal when power of self-test of
controller
Close the ignition lock and disconnect the battery
plug to confirm and replace the controller
When the vehicle is running, the temperature of
controller is too high, need to stop vehicles for a
period of time, until the temperature of controller is
normal, then, the vehicle can running again.
Accelerator
handlebar
protection
Accelerator handlebar fault
Check whether accelerator handle bar is return or
burnout, if burnout, replace a new one.
controller is under the state of
anti-theft
① Press the unlock button with remote controller
② Check, whether the anti-theft device is
damaged ,and replaced if necessary
To Next Page
Loading...
