23
6.2. Removing the Doona Car Seat
from the Doona ISOFIX Base
1.
Step 1: Rotate the Doona Car Seat handle from position C to
upright position B.
Step 2: Hold the Doona Car Seat handle with one hand, and
press the Doona release button (#3) with the other hand.
You should press down the small top button, and while it is
pressed down push the entire Doona release button (#3) for-
ward until it clicks in place and the Doona color indicator (#4)
turns red. While pressing the Doona release button (#3), tilt the
Doona toward your body until it is released from the Doona
anchor points (#1).Once the Doona Car Seat is disconnected
from the base, lift the Doona and place it outside of the car.
Step 3: Unfold the Doona Car Seat wheels, rotate and extend
the handle to ‘stroller mode’ and you are ready to go!
Note: For further information about unfolding the Doona Car Seat
and adjusting the handle, please refer to the Doona Car Seat
User Guide.
(continues on next page)
INSTALLING AND REMOVING OF THE DOONA CAR SEAT FROM THE DOONA ISOFIX BASE
To Next Page
Loading...
General