DoorKing 2358-010 User Manual

UL 325 Compliant
Use this manual for circuit board 2358-010 Revision B or higher.
HARDwired Installation/
Owner’s Manual
Tracker Expansion Board
Tracker Expansion Board
Tracker Expansion Board
Tracker Expansion Board
Copyright 2016 DoorKing, Inc. All rights reserved.
Date Installed:
Installer/Company Name:
Phone Number:
Leave Manual with Owner
Circuit Board
Serial Number(s)
and Revision Letter:
Provides Access Control System expansion to
manage Up to 24 additional Access Points.
For Models:
1833, 1835, 1837 and 1838 Multi-Door Access Controller
Quad Board
Enclosure
(Not Included)
Single Board
Enclosure
(Not Included)
34
33
32
31
30
29
28
27
26
25
24
23
22
21
14
15
16
17
18
19
20
13
12
11
10
9
8
7
6
5
4
3
2
1
ON
1
0
BOARD ADDRESS
0
9
8
7
6
5
4
3
2
1
NC
OUTPUT
RELAY
NO
NC
ALARM
RELAY
NO
NC
AUX
RELAY
NO
ENT
RESET
2358-010
RF
DATA
RF
SECURE
RF
STATUS
CODE
SENT
CODE
GOOD
CODE
BAD
Wiegand Compatable
Single Board
Enclosure
with Built-In
Card Reader
(Not Included)
2358-065-L-7-16

DoorKing 2358-010 Specifications

General

Housing Material	Metal
Power	12-24 VAC/VDC
Communication	RS-485
Operating Voltage	12-24 VAC/VDC
Weight	1.5 lbs
Warranty	2-year limited warranty

Summary

Tracker Expansion Board Introduction

General Information

Tracker Expansion Board Overview

Board Input Descriptions

Setting Board Address (Software - System Relay)

Guides on setting board addresses for system identification and relay mapping.

Relay Identification (Software - System Relay)

Explains how relays on the tracker expansion board are identified in the software.

HARDwiring

General HARDwiring Information

Provides essential guidelines for wire types, power, and grounding for hardwiring.

Board Addresses 3 - 10 Communication Line HARDwiring

Details wiring for tracker expansion boards using addresses 3-10 to Relay 2/Wiegand 2.

Board Addresses 11-18 Communication Line HARDwiring

Details wiring for tracker expansion boards using addresses 11-18 to Relay 1/Wiegand 1.

MAX Boards Communication Line HARDwiring

Basic Wiring Options at Access Point

Shows wiring for door control, gate operators, and relay configurations.

Alarm Wiring Options at Access Point

Describes wiring for alarm functions, door contact switches, and bypass modes.

All Available Devices at Access Point

Typical Dual Mode Wiring at 2 Access Points

Gate Operator Data Wiring - Optional Control Wiring

Programming

LED and Button Descriptions

Programming

Programming Step Descriptions

Details specific programming steps and their functions for board configuration.