To Next PageTo Next PageWhat to do if a Doosan Portable Generator runs irregularly?
If your Doosan Portable Generator runs irregularly or stalls frequently, start by removing and checking the thermostat. If the fuel filter is clogged, replace it. If there's water, dirt, or air in the fuel system, drain, flush, fill, and bleed the system.
What could cause failure of the entire electrical system of Doosan G60-SIIIA?
A failure in the entire electrical system of your Doosan Portable Generator could be caused by a faulty battery connection, so clean and tighten the connections. Replace the fuse if it's blown.
Why does my Doosan Portable Generator battery use too much water?
If your Doosan Portable Generator battery uses too much water, it could be due to a cracked battery case, so check for moisture and replace the battery if necessary. The battery itself might be defective, so test it. Also, the battery charging rate might be too high, so test the charging system.
What to do if the starter of Doosan Portable Generator will not crank?
If the starter of your Doosan Portable Generator will not crank, make sure the engine is not under load and remove any load if present. Clean and tighten any loose or corroded connections. Replace the fuse if it's blown.
Why is the engine temperature below normal on my Doosan G60-SIIIA Portable Generator?
If your Doosan Portable Generator's engine temperature is below normal, it could be due to a defective thermostat, so remove and check it. Another possibility is a defective temperature gauge or sender, so check the gauge, sender, and connections.
Why does the starter crank slowly on my Doosan Portable Generator?
If the starter on your Doosan Portable Generator cranks slowly, it could be due to a few reasons. Ensure you are using proper viscosity oil. Check for loose or corroded connections and clean and tighten them.
What to do if the batteries of Doosan G60-SIIIA will not charge?
If the batteries of your Doosan Portable Generator won't charge, the first step is to clean and tighten any loose or corroded connections. Adjust the belt tension or replace the belts.
Why is my Doosan G60-SIIIA system undercharged?
An undercharged system in your Doosan Portable Generator may be due to a few reasons. If you've added accessories, they might be causing excessive electrical load; remove them or install a higher output alternator. Excessive engine idling can also lead to this issue; increase the engine RPM when a heavy electrical load is used. Inspect and clean any poor electrical connections on the battery, ground strap, starter, or alternator. The battery itself might be defective, so test it. Finally, the alternator could be defective, so test the charging system.
What causes high oil consumption in my Doosan Portable Generator?
If your Doosan Portable Generator has high oil consumption, it could be due to several factors. Make sure you are using the proper viscosity oil. Check for oil leaks in lines, gaskets, and the drain plug. Also, inspect and clean the crankcase vent tube if it's restricted.
How to start a Doosan G60-SIIIA Portable Generator if it cranks but won't start?
If your Doosan Portable Generator's engine cranks but doesn't start, there might be several reasons. First, ensure you're following the correct starting procedure. Check if there's fuel in the tank and that the manual shut-off valve is open. Inspect for any exhaust restrictions and correct them. The fuel filter might be plugged or full of water, so replace it or drain the water. Also, verify fuel flow at the supply pump or bleed the fuel system. If these steps don't work, the injection pump or nozzles could be faulty, requiring professional repair or replacement.
Details unit specifications, dimensions, capacities, and airborne noise levels.
Lists electrical parameters such as apparent power, voltage, and current.
Explains the meaning and use of safety symbols and decals.
Covers critical warnings, cautions, and hazardous substance handling.
Outlines unit setup, initial checks, and pre-start procedures.
Guides on starting/stopping and explains diagnostics and control panel.
Details available options and operation of digital control interfaces.
Covers general maintenance, safety, and routine checks.
A schedule of maintenance tasks based on operating hours/time.
Details daily checks and 500-hour service procedures for engine and filters.
Covers safety rules, warning symbols, and nameplate identification.
Details technical specifications, mechanical options, and application context.
Guides on handling, coupling, location, and initial mechanical/electrical checks.
Provides wiring diagrams for different voltage and phase configurations.
General| Brand | Doosan |
|---|---|
| Model | G60-SIIIA |
| Category | Portable Generator |
| Language | English |
