Dooya DC2700 - Managing Preferred Positions; Setting a Preferred Position; Removing a Preferred Position; Deleting All Set Limits

Set Preferred Position
Check that both upper and lower limits are set.
Operate the screen to the desired preferred
position. Press P2 (1 jog and 1 beep), press STOP (1
jog and 1 beep), press STOP again (2 jogs and 3
beeps), preferred position is now set
Remove Preferred
Press P2 (1 jog and 1 beep), press STOP (1 jog and 1
beep), press STOP again (1 jog and 1 Long beep),
preferred position is now deleted
Press P2 (1 jog and 1 beep), Down and 1 beep), P2
(2 jogs and 3 beeps), all limits are now removed
On existing remote, Press P2 (1 jog and 1 beep)
Press P2 again (1 jog and 1 beep), then on new
remote, press P2 (2 jogs and 3 beeps). New remote
is now linked. Repeat for any additional remotes
Issue – Possible Cause
Solution
Motor has no response - No
Power or poor wire
connection
Check power and connections
Motor has no response -
Remote battery low
Replace Battery
Motor has no response - RF
Interference
Check motor antenna, check
for other RF source
interference
Motor has no response - Out
of remote control range
Move remote closer to unit
Motor starts slow or makes
loud noise - Incorrect
installation or overload
Verify installation is correct
and level
Motor stops during travel -
Motor has reached limit
Adjust limits
Motor stops during travel -
Run time exceeds 4 minutes
Allow motor to cool to reset
the internal thermal fuse
Screen does not reach lower
limit or goes too far into the
housing – Screen has re-
wrapped itself
Remove hood and check for
re-wrap, break limits if
needed to relieve re-wrap
Remote A → Remote A → Remote B
5 Preferred Position
6 Delete All Limits
7 Pair / Unpair Additional Remotes
8 Remove All Remotes
Troubleshooting
Press P2 (1 jog and 1 beep), STOP (1 jog
and one beep), P2 (2 jogs and 3 beeps)
9 Motor Mode Switching
Press P2 (1 jog and 1 beep), UP (1 jog and
one beep), UP (1 jog and 1 long beep)