What to do if Dorma Control Systems unit indicates an error code after an incomplete update?
If the Dorma control unit shows an error code because of an incomplete update, disconnect the system from the power supply. Then, reprogram the ESA II control unit.
General| Brand | Dorma |
|---|---|
| Model | ESA II |
| Category | Controller |
| Language | English |
Details the steps for performing the initial setup and configuration.
Explains the procedure for the door's automatic learning cycle.
Describes how to configure the panic closing function.
Explains emergency opening during a power failure.
Details emergency closing during a power failure.
Covers general emergency operation during power loss.
Describes how to disable the airlock function.
Explains the functions and operation of the program switch.
Details common errors, their causes, and recommended solutions.
Lists and explains the codes displayed on the 7-segment display.
Explains PDA error messages and methods to acknowledge them.
Describes how to operate the system using a PDA.
Details the process of updating the control unit software.
To Next Page
