Dornier Medilas H - Service Manual

Questions and Answers

A
Alec FosterAug 2, 2025
What to do if no laser pulse is emitted from Dornier Medical Equipment?
- B
  Beth BennettAug 2, 2025
  If your Dornier Medical Equipment isn't emitting a laser pulse, consider these potential causes and solutions: * The foot switch might be defective and needs replacement. * The air break switch may be defective; in this case, replace the air break switch. * Check for any leaks in the tubing, and replace the tubing if necessary. * A defective CPU could also be the reason; consider replacing the CPU board. * Inspect Cable W4; ensure it is properly connected, and replace or repair it if damaged.
J
johnsonrachelAug 6, 2025
Why does my Dornier Medical Equipment keep reporting overtemperature (error code "1")?
- S
  Samuel BurnettAug 7, 2025
  If your Dornier Medical Equipment is repeatedly reporting an overtemperature error, here are some potential causes and solutions: * The location might have restricted air change; try changing the location. * The cooling system may be dusty and needs cleaning. * The cooling fan may not be running; ensure it is properly connected or replace it. * The ambient temperature could be too high; provide sufficient room cooling or change the location. * The temperature sensor in the cooling system may need calibration. * Cable W13 might be faulty and needs replacement or repair. * The CPU could be defective, requiring replacement of the CPU board.
P
Phyllis EllisAug 12, 2025
How to fix a pilot laser that is not visible on Dornier Medical Equipment?
- C
  Caitlin RodriguezAug 12, 2025
  If the pilot laser on your Dornier Medical Equipment is not clearly visible, consider the following: * The pilot laser might be set to level 0; try setting it to a higher level. * For serial numbers less than 79, the pilot driver (A10) may not be switched on; ensure it is switched on. * Check Cable W6 for proper connection; replace or repair if necessary. * The pilot laser might be calibrated incorrectly. * The fiber may not be adjusted correctly, or the optic may be defective; adjust the pilot laser coaxially to the therapy laser beam, adjust the fiber coupler, or replace the fiber. * The pilot laser or CPU could be defective.
B
bowersaliciaAug 16, 2025
What to do if the therapeutic effect is too low with Dornier Medical Equipment?
- D
  Diana BowenAug 16, 2025
  If you're experiencing a low therapeutic effect with your Dornier Medical Equipment, here's what you can check: * The fiber or applicator might need replacement. * The fiber coupler may need adjustment; also, check the input lens and replace if necessary. * The resonator mirror may need cleaning or replacement. * The laser crystal may need replacing. * Calibration might be off; check the monitor adjustment and calibrate the device.
K
Kevin WashingtonAug 22, 2025
Why does the laser pulse abort prematurely on my Dornier Medical Equipment?
- A
  Andrew PadillaAug 22, 2025
  If the laser pulse on your Dornier Medical Equipment is aborting prematurely, the cause might be: * A defective air break switch or pneumatic potentiometer; consider replacing them. * A faulty foot switch; try replacing it.
C
Carla JohnsonAug 27, 2025
What to do if the display is dark or key presses aren't recognized on Dornier Medical Equipment?
- J
  Jason MooreAug 27, 2025
  If the display on your Dornier Medical Equipment remains dark, or key presses are not recognized, consider the following: * Cable W3 might be the issue; replace or repair it. * The control panel could be faulty; replace the control panel or let it dry slowly. * The CPU might be defective; consider replacing the CPU board.