Page 1
800-523-8499
www.dosatronusa.com
Proper protection, such as gloves, eye wear, and aprons, are recommended when disassembling a Dosatron.
Step 1: To service your D14MZ2 injector you will need
the Seal Kit (Part #: PJDI116).
Unscrew the suction hose nut and remove the suction
hose.
Step 2: Unscrew injection stem nut.
Step 3: Pull down on stem to detach from body of unit.
Set the nut and body aside.
D14MZ2 Service - Seal Kit
Service Kit Includes:
PJDI115 Check valve
assembly
JDI100 Sleeve o-ring
JDI120 Stem o-ring
J009 Plunger seal
Before we start make sure the injector is clicking. If not, be sure to watch the
D14MZ2 Troubleshooting video.
Scan the QR
code to watch
our D14MZ2
Service -
Seal Kit video.
To Next Page
Need help?
General
