Push [ENTER/MENUE] and use the up and down
keys [
] to select ArEA. Push [ENTER/MENUE]
to confirm. On the left corner of the display appears
a small 1, which indicates the selected channel. For
changing the channel use the up and down keys
[
] . Push [ENTER/MENUE] to confirm. Use the
up and down keys [
] to select the dimension
unit:
c = Centimeter
2
m = Meter
2
Push [ENTER/MENUE] to confirm.
On the display bottom appears:
00.00
For changing the number use the up key [
] . For
stepping to the next number use the key down [
].
If the requested dimension is complete then push
[ENTER/MENUE] to confirm.
1.4.7 Memory Setup [Lo6]
Only instrument with extension –LOG (e.g. P755-
LOG) have got an internal memory.
Push [ENTER/MENUE] and use the up and down
keys [
] to select Lo6. Push [ENTER/MENUE] to
confirm. Use the up and down keys [
] again to
start [on] or Stop [off] the logger. Push [ENTER/
MENUE] to confirm. Use the up and down keys
[
] again to select between automatic storage
[Auto] or manually operated storage [SPot]. Push
[ENTER/MENUE] to confirm]. Use the up and down
keys [
] again to select between to add on data
[Add] and creating a new file [nLo6]. Push [ENTER/
MENUE] to confirm. By selected automatic storage
at the end you have to select the time interval:
1 S 1 second
5 S 5 seconds
10 S 10 seconds
20 S 20 seconds
30 S 30 seconds
1 M 1 minute
2 M 2 minutes
5 M 5 minutes
10 M 10 minutes
20 M 20 minutes
By selected manually operated storage you are able
to save the measurement by pressing ESC by each
time.
Push [ENTER/MENUE] to confirm. Push [ESC] to be
back in the measuring mode. Manual storing [Spot].
Press the key [ESC] to store manually the measuring
values.
12
Unit
MENUE
Prob Lin2 CAL PrEn Chnl ArEA Lo6
DE P700 Anleitung engl. 12/11 06.12.2011 10:04 Uhr Seite 12
To Next Page
Loading...
Need help?
General
