Douglas Premier PPS-22SQ

To Next Page

Douglas® PPS-22SQ

Premier™ Portable Pickleball, 3’ x 22’ Item # 63122

PARTS LIST

REF QTY PART DESCRIPTION

A (1) Premier™ Sq, Pair (Cut to 33")

B (2) Corner Braces

C (2) End Wheel Assembly

D (2) Stabalizer Flat Legs

E (4) 3" Square x 5'6" Base Frame

F (2) Coupler Base Frames

G (1) Center Coupler Base Frame

H (1) PN-30 Pickleball Net (31” x 21’9”)

I (2) Dowels

J (1) Velcro Center Strap

(1) Hardware Bag

INCLUDES: (1) Handle

(4) Eyebolts

(6) Extra Screws

(6) Tie Wraps

(1) 3/16” Allen Wrench

(for Set Screws)

TOOLS NEEDED (NOT PROVIDED)

9/16 Wrench or Socket

Tape Measure

PAGE 1 OF 3

Need help?

Do you have a question about the Douglas Premier PPS-22SQ and is the answer not in the manual?

Summary

Frame Installation

Attach Stabilizer Legs to Corner Braces

Attach Stabilizer Legs (Ref. D) to Corner Braces (Ref. B).

Insert Vertical End Posts

Insert vertical end posts (Ref. A) into the corner braces (Ref. B).

Attach Wheel Assemblies

Attach and secure wheel assemblies to the corner braces with a 9/16 wrench.

Assemble Bottom Frame

Assemble bottom frame by sliding together bottom frame pieces (Ref. E).

Tighten Set Screws

Tighten pre-attached set screws with provided allen wrench to secure framework.

Install Eyebolts

Screw the (2) provided Eyebolts into the threaded hole at top of each vertical post.

Net Installation

Attach Cable Loop to Dummy Post Hook

Attach the 'Loop' end of the cable to the hook on the Dummy post.

Route Cable Over Pulley on Take-up Post

Bring the cable over the pulley on top of the Take-up post, down the side.

Insert Dowels Through Net Side Tapes

Insert provided dowels through the end side tapes of the net.

Attach Net Top and Bottom with Tie Wraps

Use Tie Wraps to attach the top of the net to Eyebolts and bottom to corner bars.

Install Center Strap

Install center strap over the net and secure to Center Coupler (Ref. G).