of the case (under cross support), and lower the horizontal
support on to the shim packs. Repeat on the other end of
the case.
W A R N I N G
Be certain that your hands and feet are out of
the way before lowering the case. Failure to do
so may result in serious injury.
▲
Multi-Case
1. Remove any shelves (discard the shelf clips) and/or loose
items from the cases that may interfere with case joining.
Keep all loose items as they will be used later in the instal-
lation process.
2. Follow the single-case installation instructions for the fi rst
case, excluding #6, then position the next case in the line-
up approximately 3’ away.
3. Move the second case to a position that is approximately
6" from the fi rst case, then position case on the shim
packs.
4. Push the cases tightly together, then lightly bolt them
together through the holes provided (Fig. 3). Tighten all the
joining bolts until all margins are equal. Be careful not to
over tighten.
5. The stub-up location can be found under the tank on the
customer left. See technical references on pages 4, 7 and
10 for access locations.
6. Apply case-to-case watershed (supplied) over the end
frame seam (Fig. 4). The watershed prevents water from
settling in the case joint.
7. Repeat steps 3-6 of this sequence for all remaining cases.
Be certain to properly level all cases.
8. Properly align the front panels as needed, then install, if
applicable, front panel trim (supplied).
2. Once the case is properly placed on the shim packs,
check the vertical plumb of the case by placing a bubble
level on the rear wall. Add/remove shim packs as needed.
For the horizontal level, repeat this process after placing
the bubble level on the front sill.
3. Install the bumper, if applicable, into pre-attached bumper
track and snap into place.
4. After suffi cient time has passed to allow for bumper
shrinkage, cut away the excess bumper for fi nal fi t and fi n-
ish. Be certain to use an appropriate cutting tool (tubing-
or PVC-cutter) to ensure a smooth cut.
5. Install case shelves and reconnect lights. Be aware that
differing shelf confi gurations will affect energy consump-
tion and case performance.
6. Install toekick back onto the base of case.
CASE INSTALLATION
Fig. 3 Bolt locations (QC-30-R)
9. Install the bumper into pre-attached bumper track and
snap into place.
10. After suffi cient time has passed to allow for bumper
shrinkage, cut away the excess bumper for fi nal fi t and fi n-
ish. Be certain to use an appropriate cutting tool (tubing-
or PVC-cutter) to ensure a smooth cut.
11. Install case shelves and reconnect lights. Be aware that
differing shelf confi gurations will affect energy consump-
tion and case performance.
12. Install toekick back onto the base of case.
Fig. 4 Sealing the pipe chase
WATERSHED
END FRAME
C A U T I O N
Installation of 3rd-party materials may result in
diminished case performance.
•
13
To Next Page
Loading...