Fig. 8 LED light & ring / clamp
Fig. 11 LED ring and clamp
RING
CLAMP
Fig. 10 Open clampFig. 9 Closed clamp
RING & CLAMP
SCREW
Re-installing LED luminaires:
1.
Place a ring (Fig. 11) around each end of the light rod and
rotate until both edges of the rod line-up and snap ahold
to the ridges in the ring.
2. Slide a clamp (Fig. 11) over each ring and close them
tight around the rings by clipping together the clamp ends
located above the screw opening.
3. Line-up the closed clamps (Fig. 9) and light rod with the
existing screw holes on the case and re-attach.
4. Rotate the light rod into desired position after the clamps
are • rmly re-attached.
C A U T I O N
Too much tension on the inner clamp rings while
removing them from an LED light rod may cause
breakage. Use only enough tension for removal.
▲
LIGHTING & POWER SUPPLIES
16
To Next Page
Loading...