Field Description
Console
language
Select the language for the graphical user interface .
Date formats Date format used in the console
TC vol (°C) Select the temperature used for the temperature compensated volume calculations
Level Measurement units of the product and water height
Volume Measurement units of the product and water volume
Alarm Settings
The alarm hysteresis text box is used ONLY in when there is NO alarm. This is used when there is
turbulence in the tank. This is important for relay management.
In the examples below, Hysteresis is the value interval between the yellow and red lines.
Recommended setting: 10 mm
Temperature Measurement units of the temperature of the product.
Alarm Buzzer
Continuous: The buzzer will operate continuously and will stop when the alarm is cleared or
acknowledged.
Long: The buzzer will operate for 3 minutes. It will stop automatically.
Short: The buzzer will operate for 30 seconds. It will stop automatically.
Mute: The buzzer will not operate.
The Dip-switch Settings field shows the function of the dip-switches.
M2051_r4 MagLink LX 4 and LX Plus Configuration Manual | Dover Fueling Solutions 23
To Next Page
Loading...