Dovre DV400 - User Manual

Details U.S. certification standards and approvals for the wall furnace.

Details Canadian certification standards and approvals for the wall furnace.

Advises checking local building codes for compliance and permit requirements.

Lists optional components available for the DV400 system.

Specifies required inlet and manifold gas pressures for natural and propane gas.

Provides guidance on adjusting input ratings for installations at higher elevations.

Details minimum clearances required to combustibles and venting systems.

Covers preparation, assembly, and termination steps for horizontal venting.

Details maximum distances, clearances, positioning, and ceiling preparation for vertical venting.

Requirements for venting through existing masonry chimneys using specific liners.

Requirements for incorporating existing Class A metal chimneys into the direct vent system.

Covers gas line connection, wiring, optional accessories, and thermostat requirements.

Procedures for firebox entry, log placement, and rock wool installation.

Final safety checks of wiring, gas leaks, and venting before operating the heater.

Step-by-step guide for safely lighting the pilot and main burner of the appliance.

Procedures for safely shutting off the gas supply to the appliance.

Procedures for cleaning the internal burner and control areas of the furnace.

How to visually inspect flame characteristics for proper operation.

Recommends periodic inspection of the heater and venting system for obstructions.

Instructions on how to safely clean the appliance's glass door.

Guidance on cleaning the logs within the firebox.

Outlines limitations on Heatilator's responsibility for damages and warranty claims.

Provides instructions on how to contact Heatilator for warranty service.