GREAT STUFF PRO
™
Wall & Floor Adhesive
GREAT STUFF PRO
™
Wall & Floor
Adhesive is a heavy-duty adhesive
specially formulated to bond subfloors,
drywall, paneling, foam panels and most
construction materials. Dierent from
traditional adhesives because of its
excellent bonding power on dry, damp
and even frozen lumber, GREAT STUFF
PRO
™
Wall & Floor Adhesive provides
a fast-grab tack and long-term high-
strength bond. It bonds to lumber,
plywood, particle board, masonry,
drywall, concrete and foam panels.
It is an ideal choice for anchoring,
joining and stabilizing insulated
concrete forms and structural insu-
lated panels. GREAT STUFF PRO
™
Gaps
& Cracks Insulating Foam Sealant can
be used to seal gaps in the forms and
prevent concrete leakage during the
pouring stage.
Materials Checklist
• GREAT STUFF PRO
™
Wall & Floor
Adhesive
• PRO Series foam dispensing guns
(Figure 1)
• Protective wear, including goggles,
gloves and proper clothing
• Dry cloth, putty knife or paint scraper
• GREAT STUFF PRO™ Gun Cleaner,
acetone, or other adhesive remover
Safety and Conditions of Use
• Read the label and Material Safety Data
Sheet carefully before use.
• GREAT STUFF PRO
™
Wall & Floor
Adhesive contains isocyanate and a
flammable blowing agent. Vapor may
travel to other rooms. Ensure adequate
ventilation. Shut o all pilot lights and
extinguish open flames; eliminate all
sources of ignition before use. Do not
smoke or use lighters or matches while
dispensing foam.
• Do not breathe vapor or mist. Use in
well-ventilated areas or wear proper
respiratory protection. Isocyanate is
irritating to the eyes, skin and respira-
tory system, and may cause sensitiza-
tion by inhalation or skin contact.
• GREAT STUFF PRO
™
Wall & Floor
Adhesive is very sticky and will adhere
to most surfaces and skin. Do not get
foam on skin. Wear gloves, and goggles
or safety glasses. Cured foam must be
mechanically removed or allowed to
wear o in time.
• The contents are under pressure. The
can may burst if left in areas suscepti-
ble to high temperatures, such as motor
vehicles, or near radiators, stoves or
other sources of heat. Do not lace can in
hot water. Do not puncture, incinerate
or store at temperatures above
120ºF (149ºC).
• GREAT STUFF PRO
™
Wall & Floor
Adhesive should not be used around
heaters, furnaces, fireplaces, recessed
lighting fixtures or other applications
where the foam may come in contact
with heat-conducting surfaces. GREAT
STUFF PRO
™
foam will burn if exposed
to open flame or sparks from high
energy sources, and it will start to
thermally degrade if exposed to
temperatures above 240ºF (116ºC)
for long periods of time.
Preparation
1. Remove all contaminants (water,
oil, dust, dirt, debris or other loose
materials or release agents) that may
aect the adhesion between the sub-
strates. If in doubt, conduct an adhe-
sion test, waiting at least one hour to
assess the bond.
2. If the surface area has been previously
painted, scrape away all loose or poorly
adhered paint and sand or thoroughly
roughen the surface. Conduct an
adhesion test if any previously painted
surfaces are to be bonded.
3. Whenever possible, allow any concrete
or masonry substrates to completely
cure before bonding.
INSTALLATION INFORMATION | United States /Canada | RESIDENTIAL
Figure 1.
Pro 13
Pro 14
Pro 15
To Next Page
Need help?
General