____________________________________________________________________________________________
__________________________________________________________________________________________
12
PORTSMOUTH/EXETER/CAPE
PORTSMOUTH/EXETER/CAPEPORTSMOUTH/EXETER/CAPE
PORTSMOUTH/EXETER/CAPE
COD
CODCOD
COD
(2
(2(2
(2 PUMP
PUMP PUMP
PUMP S
SS
SYSTEMS
YSTEMSYSTEMS
YSTEMS)
))
)
Your spa side control panel consists of two main parts. The control pads operate
individual functions and allow for several programming modes. The LCD Display shows
constant water temperature and will monitor various functions. When your spa is first
activated, it will go into priming mode indicated by “Pr” on the display lasting 6 minutes.
Your spa will maintain the water temperature at the programmed setting. It has been
factory set at 100° F. Temperature adjustment is controlled by pushing the “Temp”
button. The display shows the actual water temperature unless the pad is pressed. When
the pad is pressed, the display will show the set temperature. Pressing the pad a second
time will cause the set temperature to increase or decrease depending on what direction
was last chosen. Each successive press will change the set temperature in the same
direction. Set temp display will flash while you are setting temp. Display will show
constant when set temp is accepted.
If the opposite direction is desired, release the pad and let the display revert to the actual
water temperature again. Press the pad to display the set temperature, and again to make
the temperature change in the desired direction. After three seconds, the LCD will
automatically display the current spa temperature.
JET
JETJET
JET
/
//
/
PUMP
PUMPPUMP
PUMP
OPERATION
OPERATIONOPERATION
OPERATION
The Portsmouth, Exeter, and Cape Cod models are equipped with a dual pump system,
one pump operates on either high or low speed. Pressing the first “Jets” button to the
right of the display once will turn the pump on low speed. Press again for high speed and
once more for off. Pressing the second “Jets” button will turn pump two on high speed,
press button again and pump turns off. Pump two is activated only in high speed.
The low speed of the pump may activate for at least 2 minutes every 30 minutes to detect
the spa temperature and then to heat to the set temperature if needed, depending upon
mode. When the low speed turns on automatically, it cannot be deactivated from the
panel; however, the high speed may be started. If your spa is equipped with an optional
circ pump, the circ pump will monitor temperature and filter 24 hours a day.
To Next Page
Loading...