DPA 6066 - Placement of microphone; Specifications and Support; Specifications

Placement of microphone Specifications
We suggest that you expand the frame
and then place it on your head before
adjusting it to the correct size.
The microphone capsule is correctly
positioned when it sits close to (but not
touching) your face, at the corner of
your smile.
The enclosed windscreens oer
additional protection against wind and
pop noise. Gently place the windscreen
over the microphone head.
20 Hz 50 100 200 500 1 kHz 2510 20
40
dB
10
-10
-20
-30
0
Frequency response
Typical frequency response.
Directional pattern
Omnidirectional
Cartridge type
Pre-polarized condenser
Frequency range
20 Hz - 20 kHz
Sensitivity, nominal ±3 dB at 1 kHz
6 mV/Pa; -44 dB re. 1 V/Pa
Equivalent noise level, A-weighted
Typ. 26 dB(A) re. 20 µPa
Total harmonic distortion (THD)
< 1% THD up to 128 dB SPL peak
Max. SPL, peak before clipping
144 dB
Connector
MicroDot, TA4F, LEMO and MiniJack
Color
Beige, Black
DUA9531-B
(3 pcs. of relevant color included)
DUA9531-F
DUA9501 (included)