Detektor drewna, metalu i przewodów pod napięciem
8
6. If the wires are placed horizontally, the measurement should be carried out by moving the device up
and down.
Before the first use or when the battery indicator (7) is visible on the display, anew
battery must be installed Place anew DC 9 V block battery, paying attention to
the correct polarity Make sure that the connecting cables of the battery are not
crushed or damaged It is recommended to use alkaline batteries Used batteries as
hazardous waste should be thrown into specially marked containers or handed over to
aseparate collection point. Do not dispose of batteries in the trash bin Do not use
new and used batteries at the same time.
Description
J mode switch
K ON/OFF switch
L LCD screen
M detector sensor
N sound indicator
AC live wires detection indicator
P used battery indicator
Q approaching to detected element indicator
R metal detection mode indicator
S AC wires detection mode indicator
wood detection mode indicator
detected edge of element indicator
Battery replacement
1. Before the rst use or when the battery indicator P is visible on the display, anew battery must be
installed.
To Next Page
Loading...