DPM WL558W User Manual

WL558W
7
Transmitter installation 
Beforeinstallingthebutton(transmitter),checkiftheoperatingrangeofdoorbelliscorrect.Thebutton
can be mounted permanently to the mounting surface by screws.

Do not install the button (transmitter) directly on metal surfaces, as it may cause inter-
ference and reduce the range of the doorbell
/ The transmitter is recommended to be
installed in places not exposed to prolonged and heavy rainfalls and in sunny places.
If necessary, an additional cover should be used
/ When drilling assembly holes, pay
attention to the location of electric cables and other installations. It is recommended
to use adetector for detecting pipes and pipes in walls, eg KC098YB or V31 from DPM
 Before using the transmitter for the first time, remove the battery protecting tape.
Battery replacement
Transmitter

It is recommended to use alkaline batteries / Used batteries as hazardous waste should
be thrown into specially marked containers or handed over to aseparate collection
point. Do not dispose of batteries in the trash bin
/ Do not use new and used batteries
at the same time.

Hereby,DPMSolidLtdSP.k.declaresthatwirelessdoorbellWL558WisincompliancewithDirective
2014/53/EU.ThefulltextoftheEUdeclarationofconformityisavailableatthefollowinginternet
address:http://www.dpm.eu

DPM WL558W Specifications

General

Brand	DPM
Model	WL558W
Category	Accessories
Language	English