14 DR
®
SNOW BLOWER
Chapter 3: Operating the DR SNOW BLOWER
It may be helpful to better familiarize yourself with the features of your SNOW
BLOWER by reviewing Figure 2 in Chapter 2 before beginning the steps outlined
in this chapter.
Starting the PRO-24 Engine (Manual Start)
1. Insert the Key into the Key Slot (Figure 26).
2. Move the Choke Control Lever to the left “choke” position (leave in the
right “Run” position if the engine is already warm).
3. Push and release the Primer Bulb 3 times.
4. Slowly pull the Starter Cord until you feel resistance, then pull quickly
(Figure 27). The Cord will recoil back into position when released.
5. As the engine warms up, slowly adjust the Choke to the right. Wait until the
engine runs smoothly before each Choke adjustment.
6. When the Engine is warmed up and running smoothly, ensure that the
Choke is fully in the right “Run” position.
Starting the PRO-24 Engine (Electric Start)
1. Insert the Key into the Key Slot (Figure 26).
2. Move the Choke Control Lever to the left “choke” position (leave in the
right “Run” position if the engine is already warm).
3. Connect the required Heavy-Duty extension cord into the Snow Blower
Control Box (Figure 28) and plug the Extension cord into a 120V outlet.
4. Push the Starter Button on the Snow Thrower Control Box until the engine
starts and then release the Button.
NOTICE: Do not push the Starter Button more than 10 times at intervals of 5
seconds on/ 5 seconds off. If the Engine will not start, see the Troubleshooting
section in Chapter 5 of this manual.
5. As the engine warms up, slowly adjust the Choke to the right. Wait until the
engine runs smoothly before each Choke adjustment.
6. When the Engine is warmed up and running smoothly, ensure that the
Choke is fully in the right “Run” position.
Starter
Control
Box
Figure 28
Starter
Button
Starter
Cord
Figure 27
Key
Figure 26
Choke
Primer
Bulb
Read and understand all warnings listed in “Chapter 2” before operating this
SNOW BLOWER.
Read and understand the warnings listed in Chapter 2 “Safety with Extension
Cords” before connecting the Extension Cord.