WHAT HAPPENS IN CASE OF A FAILED INITIAL TEST?
In case of a failed initial test the control unit blocks
the engine start. A time-out for the Interlock 7000 is
then activated. After a defined period of time you get
the opportunity to take a new initial test. A countdown
on the display shows the time remaining until the next
initial test.
WAS THE BREATH SAMPLE SUBMITTED CORRECTLY?
If an error occurs during the breath test, the device will
alert you with audible and visual signals. If you hear
a beep during the measurement, stop blowing and
look at the display. The following guidelines will help
you to find and eliminate the problem:
– “Blow longer”
– “Blow stronger”
– “Suck after blow”
Press the “OK” button to take a new test.
D-85340-2013
To Next Page
Loading...
