IMPORTANT MAINTENANCE INFORMATION ON THE RIGGING
• Always check the rigging, halyards, reefing lines, water stays and rudder down haul
line, as well as the cable operating the swing wing system in the aft wing
• Minimum once a year shorten all halyards, reefing lines and swing wing lines by
approx. 25 cm. After some years turn them around or replace the lines
• Side stays and forestays should be changed latest after 10 years or by max 15,000 NM
• Diamond stays on the mast should be changed latest after 15 years or by max 20,000
NM
• We recommend changing the 6 mm swing wing cable in the aft wing every max. 5
years
• Never use shackles or similar on the boatman chair
• Never climb the rigging when the boat is in folded position
• Tension on the rigging, please see rig diagram
• Never change the tension on the diamonds without checking tension with a tension
meter according to rig tension diagram, changing the rig tension cause the mast to
break
• Never drill holes in the carbon mast section without asking your local dealer or
Quorning Boats beforehand
• Never wrap the mast in any plastic, as this can cause the paint to bubble. If wrapping
is needed, use breathable textile
• Wash the mast track with soap and water before stepping the mast
To Next Page
