Draper 77020 - Health and Safety Precautions; General Safety Instructions

6. Identication and Unpacking
6.1 Product Overview
– 7 –
EN
5. Health and Safety Information
– 6 –
EN
(1) Benchtop
(2) Crank handles
(3) Front legs
(4) Rear legs
(5) Clamp blocks
(6) Tool holders
(7) Folding braces
(8) Diagonal braces
Important: Read all Health and Safety instructions before attempting to operate, maintain or repair this product.
Non-compliance with these instructions may result in injury or damage to the user or the product.
5.1 General Health and Safety Instructions
• Observe all standard safety precautions and good
practices when in a workshop environment.
• Read all the safety information associated with any
tools to be used in conjunction with this workbench.
– Use all appropriate personal protective equipment
when working with tools.
– Be mindful that tools that may damage the
workbench frame or work surface if used carelessly.
• Before every use, inspect the workbench for broken,
cracked, loose or corroded parts.
Important: DO NOT use this product if it is damaged
or its structural integrity is compromised. Contact
Draper Tools to discuss repair and replacement
options.
• Ensure that the workbench is fully assembled, opened
and tightened before use, with the folding braces
locked in place.
• Ensure that the workbench is positioned on rm and
level ground while it is in use.
– DO NOT use the workbench on slippery or wet
surfaces.
• DO NOT climb or stand on the workbench.
• DO NOT exceed the rated weight limit.
– DO NOT store heavy loads on the workbench for
extended periods.
• Position the workpiece so that the weight is evenly
distributed and does not overbalance the workbench.
• NEVER clamp or mount tools to the workbench.
• DO NOT expose the product to rain or wet
environments.
• Take care when lifting or moving the workbench.
CAUTION! DO NOT overtighten the clamps.
(1)
(7)
(2)
(3)
(5)
(6)
(8)
(4)
(4)