OPERATION & USE
- 9 -
DRILLING WOOD AND PLASTIC
To prevent splitting around the drill holes on the reverse side, place a piece of scrap timber under the
material to be drilled.
DRILLING METAL
Mark the point to be drilled with a centre punch to help the drill bit tip to locate.
SCREWDRIVING
To prevent slip or damage to the screwhead, match the screwdriver bit to the screwhead size. To remove
screws move the direction switch to the reversing position and apply pressure to the screwhead and
depress the trigger slowly.
MAINTENANCE
Neither the drill or charger require any special maintenance.
Keep both the drill and the charger in a dry place where they will not be exposed to frost or direct
sunlight.
BATTERIES
IMPORTANT:
Please note all repairs/adjustments
should be carried out by a qualified person.
DRAPER HELPLINE:
(
023
)
8049 4344
STOCK Nos.: PART Nos.: VOLTAGES
65143 CBD18 18V
To Next Page
Loading...
