5. Carefully put the head assembly on
column and slide it into position. Align head
with table and base and tighten the two
hexagon head locking screws as shown in
Fig.5.
3. Assemble the table and table locking
handle Fig.3.
ASSEMBLY Cont'd
- 10 -
A
D
E
F
A
D
E
G
Fig.3.
Fig.4.
Fig.5.
4. Slide the table over the drill press column
and fasten in place by tightening table locking
handle as shown in Fig.4.
D
E
A
E
D
F
A
G
To Next Page
Loading...
