Need help?Do you have a question about the Drawmer DS404 and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| Compressor | Yes |
| Gate | Yes |
| Expander | Yes |
| Input Connectors | XLR, 1/4" TRS |
| Output Connectors | XLR, 1/4" TRS |
| Dynamic Range | > 110 dB |
| Signal to Noise Ratio | >90dB |
| Controls | Threshold, Attack, Release |
| Frequency Response | 20 Hz to 20 kHz |
| Power Supply | 100-240V AC, 50/60Hz |
| THD | <0.05% |
| Input Impedance | 10 kΩ |
| Output Impedance | 100 ohms balanced |
Covers mains fuse type, cable handling, and servicing by qualified personnel to prevent shock or fire.
Advises against exposing equipment to rain/moisture and warns about placement near heat sources or airflow obstruction.
Guides users on reporting faults, obtaining service, and returning equipment under warranty.
Lists input/output impedance, maximum levels, bandwidth, and floor level specifications.
Details the minimum and maximum values for Hard and Soft attack and release times.
Provides measured noise figures (wideband, CCIR, IEC A) and distortion percentages.
Specifies power requirements, fuse rating/type, case size, and unit weight.
To Next Page