DrBrowns AC147 - Preparing for Use; Warming Function

PREPARING FOR USE
CAUTION: Unplug from outlet before adding water.
1. Remove the reservoir from the rear of the warmer.
2.
Add water to the reservoir. Replace water after 24 hours or when water is depleted
(whichever comes rst).
3. Put the reservoir back in place. Ensure warming basket and lift-out basket are in warming
chamber. Plug into wall outlet.
CAUTION: Place appliance on a level, heat-resistant surface.
1
3
2
2
mL
Power
Starting
Temperature
Condition
Vessel/Volume/
Units Selection
Up
Cycle Start
Down
WARMING
CAUTION: ALWAYS TEST CONTENT TEMPERATURE BEFORE FEEDING YOUR BABY.
1. Follow steps 1-3 in Preparing for Use section.
2. Place item into warmer as outlined below.
BOTTLE: Remove bottle components and add storage
cap for leak-free warming. Place into lift-out and
warming baskets.
FOOD JAR: Loosen lid of food jar. Place into lift-out basket,
then lower into warming basket.
Note: This warmer should only be used with plastic and glass bottles and glass
food jars. It is not designed to heat or thaw plastic food tubs, food pouches or
breast milk storage bags.
3. Close the lid.
4. Press the
Power Button.