OSC1: Controls Oscillator 1. Best operated at 1V/Oct. Max +/-12V
OSC2: Controls Oscillator 2. Best operated at 1V/Oct. Max +/-12V
VCF: Controls the lter’s Cutoff. Best operated at +/-5V. Max +/-12V
CV: Controls both oscillators at the same time.
Best operated at 1V/Oct. Max +/-12V
ECHO: Controls the echo’s time. Best operated at 0-2,5V. Max +/-5V
GATE: Controls the envelope’s on-off. The EREBUS gate is different
from common gate controls because the ADSR envelope works in
an on/off function but the amp’s envelope has a logarithmic
opening function.
LFO/R: Controls the rate of the LFO.
Works best at +/-5V and accepts +/-10V
PW: Controls the pulse width of the Osc1 square wave.
Works best at +/-5V and accepts +/-10V
VCA: Controls the amplitude modulation of the Amp.
Works best at +/-5V and accepts max +/-10V
OUT: Master Output of the synthesizer.
It can also be connected with headphones.
IN: Mono input to the Filter. If the synth is not triggered, the sound
will not pass through.
MIDI: Midi input. Use only the type-A dedicated adapter included in the box
B. INPUTS
B. MIDI INTERFACE
2.10 Eurorack
In order to use the Hades Reissue in a eurorack case, do the following:
A. Unscrew the 4 corner bolts, which keep the module attached to the case
B. Remove the module from the case. Afterwards, unscrew the 2 bolts that connect the small PCB to
the USB adapter and detach them.
C. Plug the provided ribbon cable and connect it to the power bus board of a eurorack case.
To Previous Page
Loading...
