Need help?Do you have a question about the Dreadbox Nyx and is the answer not in the manual?
Identifies the Scale control for the first Voltage Controlled Oscillator (VCO).
Identifies the Tuning control for the first Voltage Controlled Oscillator (VCO).
Identifies the Scale control for the second Voltage Controlled Oscillator (VCO).
Identifies the Tuning control for the second Voltage Controlled Oscillator (VCO).
Identifies the control for raising the octave range.
Identifies the control for lowering the octave range.
Identifies the control for minimizing click noise in the Voltage Controlled Amplifier (VCA).
Identifies the 5V reference point, likely for calibration.
Procedure for powering the unit and allowing it to warm up before tuning.
Instructions to tune the 5V reference using a multimeter and trimmer #8.
Setting octave switches and tuning potentiometers to mid-positions.
Steps to tune the first VCO using trimpots #1 and #2 for octave accuracy.
Steps to tune the second VCO using trimpots #3 and #4 for octave accuracy.
Adjusting octave up/down functions using trimpots #5 and #6 for precise octaves.
Procedure to minimize VCA click noise using trimmer #7.
General| Polyphony | Monophonic |
|---|---|
| Envelopes | 2 ADSR Envelopes |
| USB | No USB |
| Weight | 1.5 kg |
| Type | Analog Synthesizer |
| Oscillators | 2 VCOs |
| Modulation | LFO (multiple waveforms) |
| Effects | Reverb |
| Connectivity | MIDI In |
| Keyboard | No Keyboard |
To Next Page
