14
EN
Clean the Mopping Module
1. Press the two release clips on the side of water tank, remove the
mopping module and pull the mop pad o the mopping module.
3. Clean the mop pad with water only and leave to air dry before
re-installing.
2. Pour out the water in the tank. Clean with water only and leave
to air dry before re-installing.
4. If slow water ow occurs, or the volume is not well-distributed,
please clean the air hole in the cover of the water tank.
Note: Do not expose the tank to the sun directly.
Note:
• Remove the pad from the mopping module before cleaning it, and make
sure dirty water does not ow back into the water outlet to avoid clogging.
• For optimal performance, it is recommended to replace the mop pad every
3 to 6 months.
Routine Maintenance
To Next Page
Loading...
Need help?
General
