Dreame Support Team
Note: Do not use the mop mode when no one is at home;
Do not mop on carpets; Please use detergent carefully as it may clog the filter of the
water tank.
When charging or not in use, please remove the mop module, pour the remaining
water and clean the mop to avoid mold or odor.
4. How to remove the water tank with the Dreame Z10 Pro?
A: Press the two side clips inwards and slide the water tank backward to separate it
from the robot.
5. How to start cleaning with the Dreame Z10 Pro?
A: Press the power button, it will start cleaning.
Press any button during the cleaning, and it will pause.
Note: Dreame Z10 Pro will fail to work when the battery is too low. Please charge before
using.
If the completed cleaning duration is less than 10 minutes, the Dreame Z10 Pro
will do the cleaning twice by default.
6. How does the Dreame Z10 Pro return to the Base for charging?
A: After the cleaning, the Robot will return to the Base for charging automatically.
Press the Dock button when the Robot is under Pause status.
When the Robot is charging, the power button will flash in colors: battery>15% with
White and battery <15% with Orange.
7. How to clean the main brush of the Dreame Z10 Pro?
A: 1. Face the bottom of Z10 Pro up, press the buckle to remove the main brush
protector.
2. Take out the main brush by pulling upward and clean the bearing.
3. Remove the end cover at both sides of the main brush to clean the tangled hair.
4. Cut off the tangled hair on the main brush with the cleaning tool in the box.
5. Install the main brush and press the buckles to fix the protector.
To Next Page
Loading...
Need help?
General
